
4 Yamaha Installation
Installation
ECU and KTC
The M400 Marine ECU replaces the factory ECU in the e
located behind the engine. Place a
rubber insert under the M400 and
the ECU mounting brackets
with the existing bolt holes in the plastic
bulkhead. The KTC device can be zip-
tied to a suitable anchoring position.
Immobiliser Bypass
The Yamaha Installation Set includes the
Immobiliser Bypass which replaces
the original Yamaha Immobiliser and ren
ders the PWC permanently unlocked.
To install the Immobiliser Bypass
, simply unplug the Yamaha Immobiliser and
plug the MoTeC Immobiliser Bypass into the loom. The I
behind the front storage compartment bulkhead, on th
hull.
Optional Installation - Cooling Kit
When a MoTeC Plug-In ECU is fitted, the increased
in over-heating (See Cooling).
Removing the standard engine thermostat will improve
The thermostat is located at the rear of the cylinder head.
To further assist engine cooling, extra cooling lines
u
nit to the engine. Cooling kits can be purchased from PWC parts suppliers
such as R&D and Riva.
Acceptable results have been reported using
(http://www.rd-
performance.com/newProducts/yamaha/fzr.asp
MoTeC
box which is
rubber insert under the M400 and
allign
with the existing bolt holes in the plastic
tied to a suitable anchoring position.
Immobiliser Bypass which replaces
ders the PWC permanently unlocked.
, simply unplug the Yamaha Immobiliser and
is located
de of the
could result
slightly.
rom the jet
nit to the engine. Cooling kits can be purchased from PWC parts suppliers
# 660-18001.
performance.com/newProducts/yamaha/fzr.asp
)
Comentarios a estos manuales