Motec PWC Plug-In ECU Manual de usuario descargar pdf (Pagina 28)

MoTeC Sea-Doo 2010 Installation

Installation

The M400 Marine ECU replac

es the factory ECU on top of the engine.

Remove the factory ECU (three T25 Torx screws) and pre-

assemble the

supplied mounting plate before the M400 ECU is fitted:

• Screw 4 supplied M6 Stainless nuts on the studs

protruding from the top of the mounting plate.

These serve as captive spacers. (see right)

• Invert the plate and ensure that the 3

rubber rings are seated on the rubber

bushes which are fed from the top side

of the plate. (see picture at right)

• Place the plate with rubber inserts

over the plastic mounting bracket

on the PWC.

• Firmly screw 2 x 6mm cap screws

with washers in the lower 2

positions, and 1 x countersunk

screw without washer in the central

position. Do not over tighten.

• Ensure that the rubber mat with

hole is mounted over the centre

countersunk screw.

• Fit the waterproof relay to the top right screw post

which protrudes from the mounting plate.

• Fit the M400 ECU and place the 2 stainless steel

brackets onto the 4 screw posts, after first fitting

the rubber trim strips to the underside of the

brackets.

• Secure the brackets (and relay) with 4 x M6

washers and 4 x M6 Nylock nuts.

es the factory ECU on top of the engine.

assemble the

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 90 91

Sin comentarios

Motec PWC Plug-In ECU Manual de usuario Pagina 28