Motec PWC Plug-In ECU Manual de usuario descargar pdf (Pagina 22)

MoTeC Sea-Doo 2004 – 2009 Installation

Installation

The M400 Marine ECU replaces the factory ECU on top of the engine.

Remove the factory ECU (four M6 bolts) and screw three a

nti

mounts into three of the mounting holes (see picture).

Screw the Sea-Doo ECU mounting plate to the anti-

vibration mounts using

Loctite 243 and M6x10 stainless steel countersunk screws.

Then, place the rubber backing pad on the plate and secure

the M400 Marine

ECU with the Mounting brackets using four M6x16 stainless

and four M6 stainless steel spring washers.

Finally, connect

the adaptor loom harness between the M400 ECU and the

factory wiring harness.

Note – the Sea-Doo c

onnectors are labelled A and B and are keyed so

that only the correct plug can be inserted. If the slide-

lock on the plug

will not slide shut, then the plug is fitted into the wrong connector.

For the ECU to functi

on normally all supplied devices must be connected:

• STC-

S device plugged into 6 pin socket labelled ‘STC’

•

IGN4 device plugged into 6 pin socket labelled ‘COIL’ and 4 pin

socket labelled ‘IGN’.

• DMC-

F device plugged into 12 pin socket labelled ‘DMC’.

These devices can all be secured by zip-ties.

The M400 Marine ECU replaces the factory ECU on top of the engine.

nti

-vibration

vibration mounts using

the M400 Marine

teel cap screws

the adaptor loom harness between the M400 ECU and the

onnectors are labelled A and B and are keyed so

lock on the plug

will not slide shut, then the plug is fitted into the wrong connector.

on normally all supplied devices must be connected:

S device plugged into 6 pin socket labelled ‘STC’

IGN4 device plugged into 6 pin socket labelled ‘COIL’ and 4 pin

F device plugged into 12 pin socket labelled ‘DMC’.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 90 91

Comentarios a estos manuales

Sin comentarios

Motec PWC Plug-In ECU Manual de usuario Pagina 22

Comentarios a estos manuales