Motec PWC Plug-In ECU Manual de usuario descargar pdf (Pagina 29)

22 Sea-Doo 2010 Installation

• Now plug in the Adaptor Loom –

first, Plug B into the stock wiring

harness, then Plug A.

• Next plug the M400 ECU into the Adaptor Loom.

•

Ensure that all supplied devices are connected: M400, STC

IGN4, Relay.

These devices can all be secured by zip

Warning –

the M400 ECU MUST have

firmware version 3.52P or later loaded

BEFORE this Adaptor Loom is powered

up. If you have not loade

d the firmware you

should unplug the IGN4 device and remove

all three of the injector/ignition fuses ( #7, 8,

and 9) from Fuse Box 1, and THEN load the

3.52P firmware.

Warning –

the M400 ECU should have the

relevant start file installed before the IGN4

dev

ice and Injector/Ignition fuses are re

installed.

MoTeC