Motec PWC Plug-In ECU Manual de usuario descargar pdf (Pagina 67)

60 Appendices

Note 3 – Speed

For accurate speed measurements, MoTeC recommends the use of a GPS

system.

MoTeC's 5 Hz GPS-G1 (#41300) can be wired directly

into the ECU

receive port.

GPS wiring

M400 Pin GPS Pin Function

0V AUX B15 1

Bat –

RS232-RX B18 2 RS232 GPS Data

N/C 3

5V AUX

5V ENG

A09

A02

4 5 V

GPS Speed Display on dashes.

Late model Sea-Doo crafts (2007+) transmit the

Water Speed

ECU to the dash (Custom Dataset 1, Item 4).

With a GPS Receiver connected, this dash display

can be reconfigured

GPS Speed display.

To setup the display for GPS Speed

1. On the Adjust menu, click General Setup

2. Click Communications and then click S

etup Custom Data Sets

3. Select Item 4 – Left Ground Speed (LG Spd)

and then click

Change.

4. Select the Show Non-Sensor Channels check

box.

5. Enter GPS Speed in the Search Text box and click

6. Click OK to leave the Custom Data Set screen.

7. Save the altered configuration with a new name.

Note: Sea-D

oo dashboards show a maximum speed of 70 MPH or 113 km/h.

This limitation is unaltered with the installation of the Sea-

Doo

MoTeC

For accurate speed measurements, MoTeC recommends the use of a GPS

into the ECU

's RS232

Water Speed

from the M400

can be reconfigured

as a

etup Custom Data Sets

and then click

box.

oo dashboards show a maximum speed of 70 MPH or 113 km/h.

Doo

Adaptor Loom.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 90 91

Comentarios a estos manuales

Sin comentarios

Motec PWC Plug-In ECU Manual de usuario Pagina 67

Comentarios a estos manuales