Motec PWC Plug-In ECU Manual de usuario descargar pdf (Pagina 59)

52 Appendices

Output Test Function

To test if all outputs are correctly wired to the relevant injectors and coils, the

ECU Manager software has an output test function available

menu, click Test Outputs).

you would like to use this function in a Kawasaki installation

control pins must be physically grounded, by removing them from the M400

ECU plugs and jumping to ground.

1. Unplug the M400 ECU connectors.

2. Press the single white tab on the undersi

de of the plug until it clicks

to unlock the

pin locking plate from Connector A (white plastic inserts

in the plug),

3. Extract pins A01 (white 18AWG), A23 (o

range 20AWG), and A24

(yellow 20AWG)

from the rear of the connector using firm pressure.

4. Press the

dual white tabs on the top side of the plug until it clicks

lock the pin locking plate,

5. Re-insert the ECU plugs into the M400.

6. When ready to power up the ECU and test

the outputs,

three wires to ground.

Once testing is completed, reverse the above procedure to

wires into the M400 connector.

MoTeC

To test if all outputs are correctly wired to the relevant injectors and coils, the

(on the Utilities

you would like to use this function in a Kawasaki installation

, three relay

control pins must be physically grounded, by removing them from the M400

de of the plug until it clicks

pin locking plate from Connector A (white plastic inserts

range 20AWG), and A24

from the rear of the connector using firm pressure.

dual white tabs on the top side of the plug until it clicks

the outputs,

jumper all

-insert the three

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 90 91

Sin comentarios

Motec PWC Plug-In ECU Manual de usuario Pagina 59