Motec PWC Plug-In ECU Manual de usuario descargar pdf (Pagina 82)

MoTeC Appendices

Sea-Doo Lambda Sensor (all model years)

Suitable sensor mounting position is a

t rear of exhaust manifold, next to water

fitting.

Lambda Aim Error Display (Sea-Doo 2007-

2009 only)

Sea-Doo models from 2007-2009 transmi

t the VTS Trim level from the M

ECU to the dash (Custom Dataset 1, Item 3).

With the Lambda sensor installed, this dash display

can be reconfigured

Lambda Aim Error display. This will provide ver

y useful feedback whilst

tuning.

The display can be set up, so that i

f Lambda is on Aim, the bar graph will be

centred.

An Aim error of 0.10 will move the bar to the top or bottom of the

gauge.

This function uses the IGN5 table which is included in the

Base Map

To setup the display for Lambda aim error

1. On the Adjust menu, click General Setup.

2. Click Communications and then

Setup Custom Data Sets

3. Select Item 3 – Trim Level (VTSLev)

and then click

4. Select the Show Non-Sensor Channels check

box.

5. Enter Ign Out5 Duty Cycle in the Search Text box

and

6. Click OK to leave the Custom Data Sets screen.

7. Save the altered configuration file with a new name.

Note – this function is not possible with Sea-D

oo 2010 models.

t rear of exhaust manifold, next to water

2009 only)

t the VTS Trim level from the M

400

can be reconfigured

as a

y useful feedback whilst

f Lambda is on Aim, the bar graph will be

An Aim error of 0.10 will move the bar to the top or bottom of the

Base Map

Setup Custom Data Sets

and then click

Change.

box.

and

click OK.

oo 2010 models.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 90 91

Comentarios a estos manuales

Sin comentarios

Motec PWC Plug-In ECU Manual de usuario Pagina 82

Comentarios a estos manuales